It describes the process for creating the spiral bevel gear model in SolidWorks in detail in the following flow chart.
● Step 1:
○ Create Profile in Plane Front bevel gear.
▶ All bevel and spur gear equivalent calculation parameters before modeling the gear. The governing equations exist in most manuals appliance or can be calculated using the “Parameter Gear Calculator.”
▶ Choose the Create Plane Start and new Sketch (Front Plane png)
▶ Create a tire center line for angles and profile.
▶ Draw three lines showing three different angles (root, face, and pitch).
– Select “Your Building” on online properties for each line.
▶ Make all appropriate online element
– Choose “Smart Dimension”
– Click the centreline then building line.
– Enter every angle as shown in Figure … ..
▶ Make the dimensions of the outside diameter and the diameter Pic.
– Choose “Smart Dimension”
– Click the end point of the next line and then angle the centerline
– Enter the Dimension
– Make your diameter Pitch
▶ Tie the ends of the line and online Next Pic online.
▶ Make online from online Pic to line Root
– Start the line at the end of the line field and go over the line root
– Left Click the straight line created
– Who Click change Holding Left the line joining The Address lines and Pic
– Select “Parallel” about relations in the Properties window
▶ Create lines to finish the profile dimensions
– The Dimensions A, B, C, and D can be and feature
● Step 2:
○ revolve Bevel gear profile.
▶ Exit the Sketch
▶ Choose “revolved boss / base”
▶ In Box revolve
– Highlight the first box under “revolve Parameters” by clicking on the left
– Choose the center line only Sketch
– A preview of the profile revolved Shown